Matrix Wizard in SE

[zvacman]

I'm sure this is a total rookie question but here goes anyway.  I am trying to create my Matrix in the Visualizer using the matrix wizard. I can put in the height and width no problem and then a box pops up that I have no idea what to put in. My matrix is 25 wide and 28 tall spread over 7 universes on 7 outputs. From what I've read I need to create the matrix in the Visualizer before I can work with it in the PE.  I am lost after I put in the size.  Help.

Z

[Dennis Laff]

If your going to sequence the matrix only in the pixel editor you do not need to create it in the visualizer  if however you want to sequence in superstar or sequence editor then you can create the matrix in the visualizer 

[zvacman]

27 minutes ago, Dennis Laff said:

If your going to sequence the matrix only in the pixel editor you do not need to create it in the visualizer  if however you want to sequence in superstar or sequence editor then you can create the matrix in the visualizer 

Dennis:

I need the visualizer to sequence. Have you ever used the matrix wizard in the visualizer?

Mike

[Dennis Laff]

open visualizer click on matrix   when prop box appears   start  matrix  bottom left    consecutive pixels run    horizontal snake pattern     pixel type  dmx      wide 25     high 27     lights    check show flow lines  click ok      next box click wizards     then in next box   it shows universe 1 channel 1, click now it shows universe  1 channel 26,  click again it shows universe 1 channel 51 ,click again it shows universe 1 channel 76   click again but manually change to universe  2 channel 1andrepeat process till all 7 universe are set