Channels skewed when running in DMX mode

[deej012160]

I ran into really significant lag that I believe was caused by a throughput issue running my LOR CTB16PC from the LOR USB dongle so I am now sending DMX signals to the controller.   That resolved the apparent lag issue but now my channels seem to be skewed.  When I test channels one by one here's what I get:

Channel 1 test--channel 2 lights up

Channel 2 test--channel 3 lights up

Channel 3 test--channel 1 lights up

Channel 4 test--channel 5 lights up

Channel 5 test--channel 6 lights up

Channel 6 test--channel 4 lights up

Channel 7 test--channel 8 lights up

Channel 8 test--channel 9 lights up

Channel 9 test--channel 7 lights up

Channel 10 test--channel 11 lights up

Channel 11 test--channel 12 lights up

Channel 12 test--channel 10 lights up

Channel 13 test--channel 14 lights up

Channel 14 test--channel 15 lights up

Channel 15 test--channel 13 lights up

Channel 16 test--no lights

I checked all the test signals (generated by xlights) with SACNView and the correct channels are being turned off and on, so I am certain that the DMX signals are being sent to the CTB16PC.    Any ideas?   Thanks very much.

[MSL]

Have you looked at the channel configuration to make sure what you are calling channel #1 is configured as channel #1.

 

MSL