Little_b Posted November 8, 2015 Share Posted November 8, 2015 Just wondering if anyone else has encountered this before. I have a big matrix that works really well. However there are 3 pixels in different areas that don't turn on during sequences. I replaced them thinking they were bad, but the new ones are still out. When I put the Pixcon 16 controller in test mode they turn on just fine. I went back the custom assignment I created in PE to see if they just weren't assigned, but no holes. Any ideas? Link to comment Share on other sites More sharing options...
iflights Posted November 8, 2015 Share Posted November 8, 2015 Check your sequence. Is the Pixel channel assignment correct in the sequence? Link to comment Share on other sites More sharing options...
Sully Posted November 8, 2015 Share Posted November 8, 2015 Is it happening on a full white instance only? Perhaps a power issue? Link to comment Share on other sites More sharing options...
George Simmons Posted November 9, 2015 Share Posted November 9, 2015 If it works just fine in test mode, it's almost gotta be something in the sequence. Link to comment Share on other sites More sharing options...
Sully Posted November 17, 2015 Share Posted November 17, 2015 Just a thought but I remembered turning on pixel curve in PE and then having some of my pixels off, went back to standard curve it was ok Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now