rstout@willamette.edu Posted December 7, 2014 Share Posted December 7, 2014 I was able to operate my controller and lights last year. I have everything set up. The controller is talking to the computer as I am able to test the lights and turn them on and off. I have purchased sequences and music, but there is some utility that I have to start before the sequences will run. I can't recall what that is or how to access it. I would appreciate your help to activate the missing link. Thanks in advance for your help. Ross Link to comment Share on other sites More sharing options...
mcmpros Posted December 7, 2014 Share Posted December 7, 2014 Need to start the lor control panel and then enable your show. Place your sequences in a show via the show builder. Hope I have given you the missing link Link to comment Share on other sites More sharing options...
mcmpros Posted December 7, 2014 Share Posted December 7, 2014 Need to start the lor control panel and then enable your show. Place your sequences in a show via the show builder. Hope I have given you the missing link Link to comment Share on other sites More sharing options...
crewdog89 Posted December 7, 2014 Share Posted December 7, 2014 Did you get it to work? Link to comment Share on other sites More sharing options...
rstout@willamette.edu Posted December 7, 2014 Author Share Posted December 7, 2014 Yes, I was able to get it to work. Thank you! I wrote down all of the steps in a Word doc and put it in my LOR folder so I can refer to it next year. Thanks again! Link to comment Share on other sites More sharing options...
Recommended Posts