Jump to content

Unique Show Schedule


Ineedmorelights
 Share

Recommended Posts

Ineedmorelights

I would really appreciate some help on this topic.  I am looking to create a show that will run off the SD card controller.  Here's how the show needs to run:

 

1. 4:30pm - 6:00pm Solid Lights

2. 6:00pm/7:00pm/8:00pm/9:00pm run a three sequence show (in between the shows the lights need to be solid)

3. after 9:00pm until 2:00am Solid Lights

 

I have items 1 and 2 figured out using the Hardware manager under the LOR MP3 tab, but I can't figure out how to add the shutdown sequence.  Any ideas how to make this happen?

 

Again the show is controlled from the SD card controller, so to my understanding you cannot use the show builder, correct?

 

Thanks for the help!

Link to comment
Share on other sites

You can use simple show builder with the sd card when you launch it there is an option

Link to comment
Share on other sites

Ineedmorelights

True, but how to do you add a 1.5 hr "pre-show" (4:30 - 6:00) where the lights stay on, and a 5 hr "post show"  (9:00pm - 2:00am) where the lights stay on after the hourly shows?

Link to comment
Share on other sites

Assuming this is the Showtime MP3, and not the mini-director.

 

#1 on your list would be "Show 01"

#2 - "Show 02"

#3 - "Show 03"

 

Schedule the shows to run when you want them do, based on the times.

Link to comment
Share on other sites

Ineedmorelights

Don, 

 

It is the show time director.  

 

So Show 1 would be:

4:30pm - 6:00 "pre show" lights on

6/7/8/9:00 pm run the show every hour, with lights on in between the shows

 

Then Show 2 would be:

9pm - 2:00am Lights on

 

Is that about right?

Link to comment
Share on other sites

Go back to your original post.

 

1. 4:30pm - 6:00pm Solid Lights - SHOW 01

2. 6:00pm/7:00pm/8:00pm/9:00pm run a three sequence show (in between the shows the lights need to be solid) - SHOW 02

3. after 9:00pm until 2:00am Solid Lights - SHOW 03

Link to comment
Share on other sites

Ineedmorelights

Do I use the Hardware manager or the Simple show builder?  Is there a major difference?

 

Also, thank you so much for the help!

Link to comment
Share on other sites

Use HWU for this one. 

 

Tip: Take Screen Shots before you hit save. Will make it much easier to keep track of what you programmed.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...