Jump to content

Control panel Blue bulb


a300skippy
 Share

Recommended Posts

I have Advateck controller, how do I get the blue control bulb? in my system tray? it stays red.  I tryed to enable shcedule . any ideas

 

Link to comment
Share on other sites

Don't know about Advateck controllers. However, the blue bulb in the system tray would indicate that you have:

  1. Installed the RS485 adapters correctly.
  2. Have the RS485 adapter drivers installed.
  3. Have a show created and schedule.
  4. Have enabled shows.
Link to comment
Share on other sites

Don't know if this will help but, my bulb is always red when I start LOR without my RS485 adapter plugged in. I plug it in then launch LOR and all is blue.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...