Jump to content

Hardware Utility see's my new controller but Sequence does not activate any


BobRWing
 Share

Recommended Posts

This is my second year using LOR and I added another 16PC-G3 Ver 1.07 to my CTB16PC Ver 4.32 and a 16PC-G3 Ver 1.07 So now I have three controlers I hook it all up and run the Hardware Utility and I see all three controllers and I can turn each one on so i close the Hardware Utility and run Sequence Editor and load a Sequence I go and add a new controller and do all the sequencing and when i run it the third controller does nothing. I have tried changing the order that i have them daisy chained and still I can only get two controllers to work at a time and I have swaped them around and any two will work but three not so much. any HELP would be greatly appreciated

Link to comment
Share on other sites

What is your current license level? The "Basic" license will only run two controllers. You would need to upgrade your license to a higher level in order to controller 3 or more controllers.

 

See the comparison chart here. The link above will take you to the LOR Store, on the page you would need to use to upgrade your license.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...