happydood Posted November 25, 2012 Share Posted November 25, 2012 Im new to this so this could be a easy fix for all i know. I recently bought two controller to control my lights. Everythings installed and seemed to be running well. I just started plugging in my newly setup led christmas lights to the controllers. Before finishing i went for a test trial with a few sequences i downloaded. On one song one of the outlets that was suppose to be rapidly flash then off for certain parts of the song but instead just had a stead flash the whole song. Another sequence theres parts that didnt work at all. Is there a reason for this? Link to comment Share on other sites More sharing options...
happydood Posted November 26, 2012 Author Share Posted November 26, 2012 From what im seeing is the 17-32 controller is doing the same command as the 1-16. Like the 6 on the controller one is the same movement as the outlet 6 on controller two. Link to comment Share on other sites More sharing options...
GaryM Posted November 26, 2012 Share Posted November 26, 2012 You bought ready-made sequences. Do the channel assignments in the sequence you bought match your channel configuration and display layout? Link to comment Share on other sites More sharing options...
George Simmons Posted November 26, 2012 Share Posted November 26, 2012 Sounds like both controllers might be set to the same unit ID#. Link to comment Share on other sites More sharing options...
GaryM Posted November 26, 2012 Share Posted November 26, 2012 Sounds like it might be both...same unit ID, and the assumption the sequence was plug and play. Link to comment Share on other sites More sharing options...
Recommended Posts