ekuhner Posted October 18, 2012 Share Posted October 18, 2012 Ok, i've found the how to videos on the web for adding interactive shows. but i can't figure out if i can hook inputs somehow to the controllers i already have, or if i need additonal hardware.... i bought the starter kit and added more CTB16PC to the mix so i'm at 48 channels + some Cosmic Color.if anyone has guidance on how to wire up the input buttons that would be awesome.thanks,ed Link to comment Share on other sites More sharing options...
Guest Don Gillespie Posted October 18, 2012 Share Posted October 18, 2012 I can not answer your question but some one should be able to help you with this good luck, I think Jim is in Seattle West Seattle Lights I think give him a ring he might be able to show you. Link to comment Share on other sites More sharing options...
Geoff Harvey Posted October 19, 2012 Share Posted October 19, 2012 i know that the AC controllers each support digital inputs for triggering shows under computer control because I have used these on a CTB16D for the last 3 years. In the store under accessories there is a CTB16 header board which connects to the 18 pin header on the controller. http://store.lightor.../ctinco3in.html , For the CTB16D, this provides 3 inputs / board. The data sheet that comes with the header indicates that on the PC & K boards, only 2 inputs are useable. http://www.lightoram...TB16_HEADER.pdf,While checking the LOR site for the above links, I could not find any reference to this header anywhere except in the store, and the data sheet does not seem to be listed on the support page documentation. Link to comment Share on other sites More sharing options...
Aaron Maue Posted October 19, 2012 Share Posted October 19, 2012 Check post #2 and #10 in the following thread...http://forums.lightorama.com/index.php?/topic/21349-A-How-To-Checklist-Thread Link to comment Share on other sites More sharing options...
Recommended Posts