Tracy West Posted October 14, 2012 Share Posted October 14, 2012 (edited) Ok... before I cut my RGB strip just want to make sure on a couple of things.Cut between the line that has the 120, G, R, B?Seal the cut area with silicone?I know this sounds trival but I have only a few of these strips and I cannot afford to experiment. Edited October 14, 2012 by Tracy West Link to comment Share on other sites More sharing options...
digdeepfundraising Posted October 14, 2012 Share Posted October 14, 2012 yes that is correct if your using 5050 its every 3 leds Link to comment Share on other sites More sharing options...
digdeepfundraising Posted October 14, 2012 Share Posted October 14, 2012 it should say 12v not 120 ???? like the picture below Link to comment Share on other sites More sharing options...
tjflory Posted October 14, 2012 Share Posted October 14, 2012 (edited) Yup.Cut right down the middle of the 4 little copper tabs.This is not really a one-way trip. You can always solder them back together.tj Edited October 14, 2012 by tjflory Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now