Cannot create CCR fixtures with the same Unit ID #

[heystew]

There has been mention elsewhere on the forum that you can set two CCR controllers with the same Unit ID and they will both respond to commands for that ID. I decided to try this in the Visualizer this morning and could not get it to work. Maybe i'm missing a step.

I created a 50 pixel arch (5 segments of 10 pixels). Set the Unit ID to 1 in the fixture properties.
After that I copied and pasted the fixture. Now I have two arches set to Unit ID 1 with 50 pixels.
When clicking the "Simulation Mode" button i receive the following error message. (note that if i delete either one, the simulation will play ok)

Error Message:
There are one or more errors with your simulation that prevent it from running. Please correct these errors and try again.
Fixture A - CCR 1 is not contiguous. Next pixel is 1 but should be 51
Main CCR Fixture A - CCR 1 (copy) does not have exactly 50 pixels. Check all child CCRs.

[LOR Staff]

That's a limitation of the Visualizer. 2 or more CCRs can not have the same base ID, unless they represent different pixels.