bretk Posted January 29, 2012 Share Posted January 29, 2012 anybody done this? what i am actually doing is extending the ribbon to 10 meters, thus dropping each arch from 25 pixels to 12.5 pixels. how do I form these?thanks Link to comment Share on other sites More sharing options...
LOR Staff Posted January 29, 2012 Share Posted January 29, 2012 12 1/2 pixels?I don't think you can't cut a pixel in half. Link to comment Share on other sites More sharing options...
WilliamS Posted January 29, 2012 Share Posted January 29, 2012 I think you need to make 2 of them 13 pixels and 2 of them 12 pixels, you cant extract a pixel into 2. Extending them is same as the 6803 you are already playing with cut at the points, solder on wire and go. What you may wanna do depending on your arch setup, as in they are close together have the odd pixel on the ground or in between 2 arches so each will be 12 pixels and the 13 will be the joint between them. Once again that depends on your setup. Link to comment Share on other sites More sharing options...
bretk Posted January 29, 2012 Author Share Posted January 29, 2012 I am planning on the 13 th pixel blacked out . my problem is the arch wizard will not let me make an arch 12 pixels it says the minimum resolution is 2 pixels in a 12 segment arch Link to comment Share on other sites More sharing options...
WilliamS Posted January 29, 2012 Share Posted January 29, 2012 Cant you draw a CCR? You just click out the arch with the channels. I might be mistaken but when you click on CCR wizard you actually click out the 50 pixels. Link to comment Share on other sites More sharing options...
LOR Staff Posted January 29, 2012 Share Posted January 29, 2012 1 - Use the Arch Wizard. Create a 12 pixel arch (4 Segments, 3 pixels per segment) [12]2 - Use the 'Draw CCR' command. Draw a pixel, assign it to Segment 4 of the first arch. [13]3 - Create 2 more 4x3 arches with the Arch Wizard. [37]4 - Use the 'Draw CCR' command. Draw a pixel, assign it to Segment 4 of Arch 3. [38]5 - Use the arch wizard and create the last arch. [50]6 - Assign the base unit/starting pixel/etc to all the fixtures. Link to comment Share on other sites More sharing options...
bretk Posted January 29, 2012 Author Share Posted January 29, 2012 Thanks mike! That worked! Appreciate everyone's help Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now