Guest guest Posted December 8, 2006 Share Posted December 8, 2006 I have loaded version 1.61 but every time I attempt to display a waveform, the progress bar gets all the way to the end then the program locks up with no error message displayed. I have tried this both with new and existing sequences, same result every time. I then have to kill it with task manager.Any suggestions appreciated.....Well hold the fort, it appears that if I wait it out it eventually displays and the program starts responding again... Link to comment Share on other sites More sharing options...
Guest guest Posted December 9, 2006 Share Posted December 9, 2006 How fast is your computer? I haven't tried the new version yet, but I'm hoping the waveform isn't CPU intensive like the animation window is. Link to comment Share on other sites More sharing options...
Guest guest Posted December 9, 2006 Share Posted December 9, 2006 It's a 2.4ghz P4. Response time is fine once it initially builds the waveform, but for some reason there is a fairly long delay right at the end of that process.The progress bar appears to freeze and the program becomes non-responsive. The last time I didn't kill the task and after a couple of minutes it un-froze and all was well. Link to comment Share on other sites More sharing options...
Guest guest Posted December 9, 2006 Share Posted December 9, 2006 contactmike1 wrote: How fast is your computer? I haven't tried the new version yet, but I'm hoping the waveform isn't CPU intensive like the animation window is. The waveform in 1.6.1 is not very cpu intensive. It of course does take some processor power.. Link to comment Share on other sites More sharing options...
Recommended Posts