sd card

[randall]

Ok so i have done all my sequencing. Went to show builder to load the sequences to the card and there were none of the sequences that I did in that list. Where or what am I doing wrong here. 1st year at this not sure what I am doing wrong here.

[bob]

There are a couple of things that could be going on here.

First of all, if you haven't already, select "All Files" (rather than "16 channel" or "32 channel") from the "Files Available for Show" section.

If that doesn't help, then perhaps the files are not in the default directory, which is the only place that the Simple Show Builder looks. So, in that case, resave the files to the default directory (which is the directory that the Sequence Editor will save a brand new sequence to, unless you explicitly direct it to save it somewhere else).

[randall]

Thank you. That worked. Now just have to make note of this in my note book I have started for this. Been taking lots of notes trying to keep all this info jotted down till I memorize it all. There is more to getting started than I thought there would be.