Servodog set-up

[metallus2000]

Has anyone worked out the kinks using Servodog and talking skulls? Having a bit of a difficult time getting the "range" etc down.



By the way I set-up my servodog board in a cheap (latched) tool box with a 12v 6 amp ps...picture below.


Attached files .JPG"]

[metallus2000]

One of the problems I am running into is that the jaw pops fully open when the sequence starts.

[dgtlpro]

metallus2000, One thing you can try is to set a default position, and set-up some virtual limits.

[metallus2000]

I did figure out that if I turn the channel on the mouth closes, so I have something off. By leaving blank spaces I can get the skull to "talk".

[metallus2000]

Nice thanks. I have been slowly figuring this out. I'll post my video of the Nox Arcana song "Dead men tell no tales" ALmost got it. I did notice by leaving the lights on checked it helped not having an open mouth at the end.

Thanks for the help :-)

[metallus2000]

Jeff do you have any servdog sequences I could look at? I have a few sequences I could trade. I am trying to get a feel for the whole 0-50-100% deal and seeing another one would help :-)