Guest guest Posted November 25, 2006 Share Posted November 25, 2006 DID A HARDWARE TEST AND EVERYTHING SEEMS TO WORKALL (3) 16 CHANNEL CONTROLLERS TESTED OK.WHEN I TRY TO OPEN A SHOW OR CONTROL THE LIGHTSFROM A SEQUENCE, IT DOES NOT WORK. AUDIO PLAYS BUT NO LIGHTS!!ANY IDEAS WHERE I MESSED UP.THANKSRICK Link to comment Share on other sites More sharing options...
Guest guest Posted November 25, 2006 Share Posted November 25, 2006 Harbs wrote: DID A HARDWARE TEST AND EVERYTHING SEEMS TO WORKALL (3) 16 CHANNEL CONTROLLERS TESTED OK.WHEN I TRY TO OPEN A SHOW OR CONTROL THE LIGHTSFROM A SEQUENCE, IT DOES NOT WORK. AUDIO PLAYS BUT NO LIGHTS!!ANY IDEAS WHERE I MESSED UP.THANKSRICKDid you configure the channels in your sequence? It sounds like the shows are programmed, but they don't know what channels to fire. Open a sequence, and right click on a channel, then click "Change Channel Settings." If the last three boxes have not been configured, then your lights will not work. Link to comment Share on other sites More sharing options...
Guest guest Posted November 25, 2006 Share Posted November 25, 2006 Your were right!!I had the sequence done on my desktop correctly butI used one on my laptop and it was not configed for the channels.Thanks for your help!!Rick Link to comment Share on other sites More sharing options...
Recommended Posts