Guest guest Posted November 25, 2006 Share Posted November 25, 2006 WHen I hook up the cat 5 cable the red light stops blinking but when I hit refresh it will not recognize the first board. Same goes for the 2nd board light stays on but nobody is home.......I have taken it out of line up and hooked up directly to computer but still not working. any suggestions..? we are going nuts over this. The boards worked fine last year. Link to comment Share on other sites More sharing options...
Guest guest Posted November 25, 2006 Share Posted November 25, 2006 Patty:Had same thing happen to me earlier this year. Dan told me to use hardware utilty and reset the ID by using "any unit" for the selection and then put in the ID you want for the show. Only have one unit connected to the computer at one time!Mike Link to comment Share on other sites More sharing options...
Guest guest Posted November 25, 2006 Share Posted November 25, 2006 You are my HERO!! Thaks so much it's been driving me crazy!!!!Patty Link to comment Share on other sites More sharing options...
Guest guest Posted November 25, 2006 Share Posted November 25, 2006 No, it was our man Dan from LOR - just passing on his genius!Mike Link to comment Share on other sites More sharing options...
Recommended Posts