Guest guest Posted November 12, 2006 Share Posted November 12, 2006 I have 3 CTB16KD boards that will draw a total of 28 amps. I want to run 2 dedicated 20 amp circuits. Can I have one of the circuits power both sides of board 1 and the left side of board 2 and can I have the other circuit run the right side of board 2 and both sides of board 3? I don't see any reason why I couldn't but I wanted to check first. Link to comment Share on other sites More sharing options...
Guest guest Posted November 12, 2006 Share Posted November 12, 2006 Your plan will work fine. I assume that you have built all of the board with two male power plugs (not just one). If you have one one plug on board 2 you will need to remove tyhe jumpers and install an additional power plug. Link to comment Share on other sites More sharing options...
Guest guest Posted November 12, 2006 Share Posted November 12, 2006 Bill Foley wrote: Your plan will work fine. I assume that you have built all of the board with two male power plugs (not just one). If you have one one plug on board 2 you will need to remove tyhe jumpers and install an additional power plug.Yup, Board two has two plugs. Link to comment Share on other sites More sharing options...
Recommended Posts