Guest guest Posted November 11, 2006 Share Posted November 11, 2006 My configuration consists of a laptop controlling 3 LOR boards. However, the layout makes it difficult to make an "in order" connection.Laptop>LOR Unit 1>LOR Unit 2>LOR Unit 3Can I wire in any order, as long as the Unit ID's are correct? It would be much easier for me to wire it like:Laptop>LOR Unit 2>LOR Unit 1>LOR Unit 3Can this be done or must they be linked in order?Thanks, all!~K Link to comment Share on other sites More sharing options...
Guest guest Posted November 11, 2006 Share Posted November 11, 2006 It does not matter the order as long as you set the unit ID's correctly.Robogeek Link to comment Share on other sites More sharing options...
Guest guest Posted November 11, 2006 Share Posted November 11, 2006 Yes, you'll be fine in any order.Tom Link to comment Share on other sites More sharing options...
Guest guest Posted November 11, 2006 Share Posted November 11, 2006 When you set the ID number this makes the controller unique. It will only recognize commands that are sent to that particular controller. All other will be ignored. I have 19 controllers and they are all over the place so you will have no problem. Link to comment Share on other sites More sharing options...
Guest guest Posted November 12, 2006 Share Posted November 12, 2006 Thanks, everyone. That's a big help! Link to comment Share on other sites More sharing options...
Recommended Posts