michaelc Posted December 17, 2010 Share Posted December 17, 2010 I don't understand how the 1st unit of my network can be steady signal, the 2nd is blinking and the 3rd and 4th are steady blinking. Lights are erratic. Some are on and following sequence and some are not, regardless of whether the signal LED is blinking? ANy ideas? Link to comment Share on other sites More sharing options...
George Simmons Posted December 17, 2010 Share Posted December 17, 2010 What do you mean by "steady blinking"? How is this different than what unit two is doing? Controllers with the red light blinking aren't connected to the network or aren't being recognized by the network. What kind of controllers? Link to comment Share on other sites More sharing options...
michaelc Posted December 17, 2010 Author Share Posted December 17, 2010 It is blinking the same pattern as if it didn't have a signal. So I have solid LED on the 1st controller, blinking 2nd , solid on #3 and solid on #4.I set the codes to 00 and did a reset. It is finally steady on. I did a full power cycle and now it 'appears' to be working.Strange thing was that even though it was blinking the Harware utility was reporting 'seeing' it. Link to comment Share on other sites More sharing options...
garyfunk Posted December 21, 2010 Share Posted December 21, 2010 Yes, what Jeff said. Link to comment Share on other sites More sharing options...
michaelc Posted December 21, 2010 Author Share Posted December 21, 2010 Thank guys, I gave the box a kick and it seems to be working now. Only kidding. I think it was hung and the reset took care of it. It's been working now for several nights without incident. Link to comment Share on other sites More sharing options...
Recommended Posts