Guest guest Posted December 6, 2005 Share Posted December 6, 2005 I have a ctb08 in my chain of LOR boards. It's acting really weird. The led stays on, but the board kind of shuts down about every 25 mins. If I unplug and plug it back in it works fine again, for another 20 or 25 mins. Any suggestions? All of the boards before and after it still work fine. Thanks for any help.Bill Link to comment Share on other sites More sharing options...
Guest guest Posted December 6, 2005 Share Posted December 6, 2005 If it is a V4 then make sure the jumper is removed. The V4 has a single jumper on it next to the Comm connection. The V4 also has 3 connectors (2 RJ45s and 1 RJ11)... Link to comment Share on other sites More sharing options...
Guest guest Posted December 6, 2005 Share Posted December 6, 2005 Dan, It is a v4, and the jumper was removed. I used the same board last year. We had a big ice storm Saturday night and all the connections were covered with ice, that might have something to do with it, not sure. Will setting it to 00 work on v4's?Bill Link to comment Share on other sites More sharing options...
Guest guest Posted December 7, 2005 Share Posted December 7, 2005 Bill,I am not sure what is going on! Do you just unplug it then plug it back in immediately and it works?When this card is stopped you say the LED stays on. Does it say on steady?I do not think that the storm caused the problem. (but I am not sure what the problem is so???) There is no "00" reset with a CTB08 V4.Send an emal to me at info@lightorama.com (subject: CTB08 Problem)... Link to comment Share on other sites More sharing options...
Recommended Posts