txfirecop Posted May 3, 2014 Share Posted May 3, 2014 Just started to test my new CCR's and am running into a problem. Have the latest firmware 1.17 and have changed all components with the same result. When I am in the Hardware Utility and select test at 100%, only about 10 pixel's are on with the last one a light green color. I reset the controller and the ribbon test just fine. I also tried an animation sequence with no ribbon response at all. I ran it through the verifier and get this message: Old MC-P compatibility enabled Message 44. Any suggestions? Link to comment Share on other sites More sharing options...
txfirecop Posted May 3, 2014 Author Share Posted May 3, 2014 Just tried my 2 yr old controller and all work as expected. Surely the three new controllers I just tried are not defective. Hopefully its a setting. Link to comment Share on other sites More sharing options...
txfirecop Posted May 3, 2014 Author Share Posted May 3, 2014 Finally figured it out. Stupid mistake and huge brain fart! Link to comment Share on other sites More sharing options...
Recommended Posts