Brandon Kibler Posted December 17, 2008 Share Posted December 17, 2008 One controller won't work in a couple of my sequnces, but will in others. All the units are set right. Not sure why it won't work in some sequnces, but will in others. Any help would be great!-Brandon Link to comment Share on other sites More sharing options...
Fred Posted December 18, 2008 Share Posted December 18, 2008 Brandon, I suspect that your channels are not properly assigned in the sequences that are giving you problems.Open one of the sequences that's giving you problems, then cllick on each channels to see their Channel Settings. Make sure the "Device Type", "Network", "Unit", and "Circuit" are set properly for every channel. I'll bet you spot a problem. Link to comment Share on other sites More sharing options...
Don Posted December 18, 2008 Share Posted December 18, 2008 Brandon Kibler wrote: One controller won't work in a couple of my sequnces, but will in others. All the units are set right. Not sure why it won't work in some sequnces, but will in others. Any help would be great!-BrandonAre you talking about some of the effects will not work correctly, or that they won't work at all? Link to comment Share on other sites More sharing options...
iresq Posted December 18, 2008 Share Posted December 18, 2008 Like Fred said, it sounds like a configuration issue. You can also use the tools channel property grid to get an overall look at your configuration settings. Link to comment Share on other sites More sharing options...
Brandon Kibler Posted December 18, 2008 Author Share Posted December 18, 2008 That was the problem, but I swear it wasn't that way last night. Thanks again, guys! Link to comment Share on other sites More sharing options...
Recommended Posts