Shawn1019 Posted August 21, 2012 Share Posted August 21, 2012 I have recently bought a servodog and a 12 Volt 6 amp power supply. (http://www.seasonalentertainmentllc.com/store/en/transformers/36-12-volt-6-amp-power-supply.html) I have no clue of how to hook up the power supply to the srevo dog. I have looked at the instructions for the servo dog but still have no idea on what wires go where. Link to comment Share on other sites More sharing options...
TJ Hvasta Posted August 21, 2012 Share Posted August 21, 2012 (edited) I just got one to play with ... along the long side, bottom of the board (Cat5 sockets on left side) you'll see a block with 4 screws in the middle of the bottom side.. it says S, G, M1 & M2.. the Pos 12vdc goes into the V and Neg goes into the G. Download the manual off the LOR website, it has some good pix, shows what goes where. You will also need the SD Config Utility program. Its in the LOR Software that you installed. Go to All Programs, Light-O-Rama, scroll down to the SD Utility. Use this to set the limits of the servos so you dont break a servo arm. I just started using this one I have and my learning curve is a vertical line. Edited August 21, 2012 by TJ Hvasta Link to comment Share on other sites More sharing options...
Shawn1019 Posted August 21, 2012 Author Share Posted August 21, 2012 Thanks TJ. I finally have it working. Link to comment Share on other sites More sharing options...
TJ Hvasta Posted August 21, 2012 Share Posted August 21, 2012 Good to hear.. Link to comment Share on other sites More sharing options...
Recommended Posts