Help! Comm port tied up and show won't work.

[timhoward]

Hi LOR's,

I have everything working except for the Show.  All lights work when I use the Hardware Utility and the Sequence Editor but when I go to run the show only, I get a comm error that it is already in use.  I've shut down, rebooted, ensured neither the HU or Sequence Editor were on.  The LOR is red in the system tray.  The LORCommListerner window keeps popping up and show the connection is accepted.  Not sure if the CommListerner should be running (maybe that is causing the problem?) but every time I kill it, it pops right back up. 

I'm on a laptop using Comm 4 and have searched through all the forums to try to find an answer to this.  I even have looked at all the processes to try to identify if there was another process tying up the port but can't find one.  A picture of the LORCommListerner is attached, maybe that will give a clue?

Any help would be greatly appreciated.  I have a whole neighborhood waiting for me to fire it up!!