rbmurray210 Posted November 11, 2013 Share Posted November 11, 2013 hey folks, I have hooked my board up and everything works fine, but when I go to hook all my units (2-16 channel +board) it will not reconginize the board. I hooked the board up by itself and the hardware utility shows this as unit 01-unknown device. when I go to try to change it to unit 03 in the utility I get "Unable to change unit id, try again" I have done this like 4 times no luck. unplugged, rebooted computer etc. has anyone else ran into this? Link to comment Share on other sites More sharing options...
Don Posted November 11, 2013 Share Posted November 11, 2013 I *think* the only way to set the address on the CMB24D is via the DIP switches. See page 8 of the docs. Link to comment Share on other sites More sharing options...
rbmurray210 Posted November 11, 2013 Author Share Posted November 11, 2013 you are correct.....thanks switch 8&9 on for unit 03.thanks Link to comment Share on other sites More sharing options...
vdipaola73 Posted November 11, 2013 Share Posted November 11, 2013 I did the same thing. The only change is if you are running in DMX. The IDs change. Link to comment Share on other sites More sharing options...
Recommended Posts