mmais68569 Posted December 28, 2009 Share Posted December 28, 2009 I have been playing with a few test setups for next year & have noticed LOR defaultsor appears to default to 50% intensity. I have used this setting for 2 years & it looks good. If I set the intensity up to lets say 75% or 100% will that set all lights in the sequence to that setting or is there a way to set only select channels to a greater intensity? Thanks Mike Link to comment Share on other sites More sharing options...
shfr26 Posted December 28, 2009 Share Posted December 28, 2009 I believe that if you use custom," the star," then to the left use the intenisty tool, you can set it. Also if you have only one channel selected it will only effect that channel. If I am wrong, I'm sure someone will point out the error of my ways:D Link to comment Share on other sites More sharing options...
iresq Posted December 28, 2009 Share Posted December 28, 2009 Setting intensity only effects those cells that the effect is applied too. The default setting is 50%. Changing the intensity setting will only effect the sequencing done after the change. The previously recorded intensity settings will remain.Global intensity settings can be fixed in the hardware via the hardware utility. Link to comment Share on other sites More sharing options...
cmoore60 Posted December 28, 2009 Share Posted December 28, 2009 LOR has 2 intensity tools. The first is where you and customize the values that you wish to use This is under the tools menu and is call intensity tool options. The second tool is also located under the tool menu and is title intensity tool settings. When you open this second tool it gives you the values that are set in the first tool. The radio button selects what intensity level is active when you select the set intensity button for programming the events.I just tried and if you select a value and exit. The intensity tool setting goes back to the middle position or 50%.Chuck Link to comment Share on other sites More sharing options...
Recommended Posts