rmkrause Posted December 8, 2009 Share Posted December 8, 2009 Is there any way to have a vertical line following the arrow (cursor)? This would help in selecting the correct area to turn on, off etc. My eyes are getting too old. Link to comment Share on other sites More sharing options...
blainedead Posted December 9, 2009 Share Posted December 9, 2009 You can always send it to the wish-list. http://lightorama.mywowbb.com/forum25/12298.html Link to comment Share on other sites More sharing options...
jimswinder Posted December 9, 2009 Share Posted December 9, 2009 you can always change your arrow (cursor) into a crosshair.find some here:http://www.rw-designer.com/cursor-set/advanced-crosshair Link to comment Share on other sites More sharing options...
bob Posted December 9, 2009 Share Posted December 9, 2009 If you have the waveform display turned on (for a musical sequence), there will be a vertical line in there that follows the cursor. It won't extend into the sequence grid, though. Link to comment Share on other sites More sharing options...
rmkrause Posted December 9, 2009 Author Share Posted December 9, 2009 Thanks for the replies guys, I do use the wave form as you suggested but some times when there is crowding it's tough to tell where you're at. I tried the cross hair cursor site but could not get it to work. Link to comment Share on other sites More sharing options...
Recommended Posts