Bruce Kryfka Posted November 29, 2009 Share Posted November 29, 2009 This is my first year running a 32 channel setup. After setting up my controllers and finally getting the hardware program too realize that I had 2 controllers.After enabling the show to start at 5:00 it worked at least the music and a few lights came on not the 32 that I have. I've tried everything possible that I could think of and still nothing to go on. Earlier in the day I did a complete check to make sure all the lights were working with no problem. Now I get almost nothing.Maybe I was expecting too much from the system. I've just started but I am ready to throw in the towel. Any ideas.Bruce Link to comment Share on other sites More sharing options...
Don Posted November 29, 2009 Share Posted November 29, 2009 I would suggest running the LOR Verifier program. I can possibly tell you where the problem is. Link to comment Share on other sites More sharing options...
Bruce Kryfka Posted November 29, 2009 Author Share Posted November 29, 2009 I've ran verify and there are no warnings or errors. Link to comment Share on other sites More sharing options...
SteveA Posted November 29, 2009 Share Posted November 29, 2009 Check in your sequance editor and see if you asigned a controller to the channels. Link to comment Share on other sites More sharing options...
cenote Posted November 29, 2009 Share Posted November 29, 2009 Start by checking with hardware utility. If all works there, might want to double check that you have not assigned the same ID's in your channels. I know from past experience, that if you have one or two that are the same in different channels, it will do crazy things.Report back, there are great others here that can help Link to comment Share on other sites More sharing options...
cenote Posted November 29, 2009 Share Posted November 29, 2009 Also check to make sure you assigned the right LOR boxes to channels in sequences Link to comment Share on other sites More sharing options...
Bruce Kryfka Posted November 29, 2009 Author Share Posted November 29, 2009 Success First I reassigned my controllers with new ID's and then I also found out that my sequences were not assigned to the correct controller. I fixed that and everything works. You members are superb I can't thank you enough.I guess this season will go on after all. Thanks to all for the expert advise. Link to comment Share on other sites More sharing options...
cenote Posted November 29, 2009 Share Posted November 29, 2009 Glad to hear it all worked, Have fun, Happy Holidays Link to comment Share on other sites More sharing options...
Recommended Posts