FandomFilms Posted November 27, 2009 Share Posted November 27, 2009 I sent two boards out for repair and got them back Wed. I put them together this morning and set them up. One of the units I connected directly to it and it told me that it didn't know what the unit was. The red light was solid. So I figured I'd update the firmware to see if that would help as this is my oldest controller.After the firmware update the pc saw the controller but wouldn't turn on any lights in test mode. I Did a test on inputs and it saw 2 of the 16. I'm not sure why its being seen and not turning lights on.Any suggestions?? Link to comment Share on other sites More sharing options...
Westport Lights Posted November 28, 2009 Share Posted November 28, 2009 Did you set the unit ID? Link to comment Share on other sites More sharing options...
FandomFilms Posted November 28, 2009 Author Share Posted November 28, 2009 yes Link to comment Share on other sites More sharing options...
Max-Paul Posted November 28, 2009 Share Posted November 28, 2009 hey cant hurt,Do a controller reset. and maybe a computer reset. But I am thinking a controller reset might do the trick. Link to comment Share on other sites More sharing options...
FandomFilms Posted November 29, 2009 Author Share Posted November 29, 2009 The board is seen by the network. I'm wondering if it's not communicating out because of something in putting the board back in. Could a crossed wire do something along these lines? or a fuse? or something in the board itself? Link to comment Share on other sites More sharing options...
Recommended Posts