jimswinder Posted November 26, 2009 Share Posted November 26, 2009 Hey...When does the LOR red LED lights stop blinking showing a connection?As soon as you enable shows...or not until an actual show starts?Only 7 hours till showtime...if I can get this work!!! lol Link to comment Share on other sites More sharing options...
Brian Mitchell Posted November 26, 2009 Share Posted November 26, 2009 Lights on the controller should go solid whenSequencer is open or Hardware Utility is open or Show is Enabled Link to comment Share on other sites More sharing options...
jimswinder Posted November 26, 2009 Author Share Posted November 26, 2009 Hmmmm...If I use the sequencer, my lights will work and red LED's are solid...but when I enable shows, LEDS just sit there and blink... Link to comment Share on other sites More sharing options...
basis21b Posted November 26, 2009 Share Posted November 26, 2009 Make sure that the sequence editor or the hardware utility is not running. They don't play well together with the Show. Link to comment Share on other sites More sharing options...
Recommended Posts