Guest guest Posted July 26, 2006 Share Posted July 26, 2006 I just finished soldering everything together. Like it said in the manual, I should check things before putting the heat sink on. All my solder connections look pretty good.When I plug it in, the LED lights and stays on. Any ideas where my problem might be.It stays lit whether or not the cat 5 cord is plugged in. When using the hardware utilty it can't find the controller. Link to comment Share on other sites More sharing options...
Guest guest Posted July 26, 2006 Share Posted July 26, 2006 Check that the processor chip is inserted with the correct orientation. Notch should be towards the LED side of the card. Link to comment Share on other sites More sharing options...
Guest guest Posted July 26, 2006 Share Posted July 26, 2006 Thanks so much DAN. I can't believe I missed that. If that was my only mistake, then I guess I can't complain. I guess with this sucess, I'll celebrate by ordering my second kit. Thanks again, now I can sleep soundly tonight. Link to comment Share on other sites More sharing options...
Recommended Posts