Jump to content
Light-O-Rama Forums

Channel wont close light stay on all the time


Danbel

Recommended Posts

Went plug my controller channel 1 ,2 and 4 go on I have no network cable connect on

I connect my network cable I went to LOR Hardware I did some test All another channel working good . I update my CTB16pc to v 4.32 I try console test I try twink Shimmer etc.... nothing change on 1,2,4 they stay on 100% Is there something wont with my triac or some resistor?? Thank Daniel:)

Link to comment
Share on other sites

Try resetting the controller.


  1. With the power off - pull off the jumper that's on the 2nd set of pins by the LED on the board.
  2. Power up the board - the LED should flash a quick flash.
  3. Power down the board.
  4. Put the jumper back on the second set of pins.
  5. Test the controller.

Link to comment
Share on other sites

Papa-LF wrote:

Try resetting the controller.


  1. With the power off - pull off the jumper that's on the 2nd set of pins by the LED on the board.
  2. Power up the board - the LED should flash a quick flash.
  3. Power down the board.
  4. Put the jumper back on the second set of pins.
  5. Test the controller.


Thank for reply Papa-LF OK it work for channel 1 is ok now channel 2 when down 50% channel 4 100% on So 2 channel still on Thank Daniel
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...