fitzer Posted October 27, 2009 Share Posted October 27, 2009 Hi,I can control my lights using the hardware utility and test my lights successfully. But when I run sequences the lights don't come on. I'm sure the unit number is correct but it still won't work.Having changed from LOR1 to S2 recently, I assume that shouldn't affect anything.Any help would be appreciated.Michael Link to comment Share on other sites More sharing options...
vipzach Posted October 27, 2009 Share Posted October 27, 2009 On the play tab, make sure that control lights is checked. Link to comment Share on other sites More sharing options...
-klb- Posted October 27, 2009 Share Posted October 27, 2009 Also make sure that the com port you are using in the hardware utility is the one configured to play shows. Sometimes, if the hardware utility did not exit cleanly, a reboot may be required. Link to comment Share on other sites More sharing options...
Tim Fischer Posted October 27, 2009 Share Posted October 27, 2009 And of course, double check your channel configuration in your sequences... (this trips up more than a few people...) Link to comment Share on other sites More sharing options...
Recommended Posts