Max-Paul Posted March 21, 2009 Share Posted March 21, 2009 I see that if one goes to the configure button in the hardware utility program. That one can lower the max intesity to less that 100%. But looks like maybe no lower than 80 something. I just converted some 18" spiral trees to LEDs. As they flash in a sequence, ones eyes start to get spots like from a camera's flash. Surely this is to bright. Playing in the console mode you can smoothly adjust the master intesity and I found that 50% is more than enough. I would like to set the controller than have to do this programaticly in the individual channels.ThanksMax Link to comment Share on other sites More sharing options...
iresq Posted March 22, 2009 Share Posted March 22, 2009 I believe that the intensity settings apply to the entire controller, not just individual channels. I think this was a power saving option however a 20% decrease results in very low power savings.So you are left with redoing your sequences via the editor or XML. Link to comment Share on other sites More sharing options...
Max-Paul Posted March 23, 2009 Author Share Posted March 23, 2009 iresq,sure glad that I have not done more than 1 seq. and not all of it as of yet. So, set my fade settings so that nothing goes over 50 and going back and reseting all fades to this new value.Thanks for your input, even if it was not what I was hoping for.Max Link to comment Share on other sites More sharing options...
Recommended Posts