Ponddude Posted January 30, 2009 Share Posted January 30, 2009 Can you use 2 inputs on the same network?I have CTB16PC's and I know you can only use two of the inputs on the new trigger card, but can I put 2 cards on the same network? Basically 1 card on one board and another card on another board? Link to comment Share on other sites More sharing options...
-klb- Posted February 3, 2009 Share Posted February 3, 2009 As I read it, the PC cards can only use two triggers per card, but you can have triggers on any/all of your cards... I haven't tested any of it yet.. Link to comment Share on other sites More sharing options...
Dennis Cherry Posted February 3, 2009 Share Posted February 3, 2009 -klb- wrote: As I read it, the PC cards can only use two triggers per card, but you can have triggers on any/all of your cards... I haven't tested any of it yet..Both directors have triggers also. Link to comment Share on other sites More sharing options...
Alan C Posted February 3, 2009 Share Posted February 3, 2009 When you set up a "triggered sequence" in the show editor, part of the setup involves specifying which unit and input is required to play the sequence. This would seem to suggest that you can use inputs on all the units if you want.Regards,Alan. Link to comment Share on other sites More sharing options...
Ponddude Posted February 3, 2009 Author Share Posted February 3, 2009 I figured as much I was just making sure. I have an idea of using one set for an alarm system and another set to have push buttons throughout the yard. Link to comment Share on other sites More sharing options...
Recommended Posts