randyd1 Posted December 8, 2008 Share Posted December 8, 2008 I have added 2 new controllers to my system and they turn on thru hardware utility and I set the new ID for them and when the show comes on they are not working.I went through the sequence editor and added 32 new channels and save it.Any solutions Link to comment Share on other sites More sharing options...
randyd1 Posted December 8, 2008 Author Share Posted December 8, 2008 randyd1 wrote: I have added 2 new controllers to my system and they turn on thru hardware utility and I set the new ID for them and when the show comes on they are not working.I went through the sequence editor and added 32 new channels and save it.Any solutions Link to comment Share on other sites More sharing options...
cmoore60 Posted December 8, 2008 Share Posted December 8, 2008 did you put any event in the squence? on/off, twinkle, shimmer Link to comment Share on other sites More sharing options...
randyd1 Posted December 8, 2008 Author Share Posted December 8, 2008 What I did was I went into each sequence that I have and added 32 more channels and copy and paste the sequence. Link to comment Share on other sites More sharing options...
cmoore60 Posted December 8, 2008 Share Posted December 8, 2008 copy and paste sequence?So check your channel property grid to make sure that your channels are indeed configured to your operation.Chuck Link to comment Share on other sites More sharing options...
randyd1 Posted December 8, 2008 Author Share Posted December 8, 2008 Thanks Chuck, I forgot that I had to do that. Link to comment Share on other sites More sharing options...
Recommended Posts