Harbs Posted December 8, 2008 Share Posted December 8, 2008 I have an older LOR board 16 channels (blue board) using a single power cord.Several of the channels are staying on all the time.They are real dim and work fine but they stay on when they are not being activated by the sequence.They are very low intensity and the higher intesity works properly when activated in the sequence.Any ideas. May need rest. If so, how do you reset the blue boards?Harbs Link to comment Share on other sites More sharing options...
cmoore60 Posted December 8, 2008 Share Posted December 8, 2008 You can try a reset. However by your description of them being on a lower intensity. I would say you have blown triacs on those channels. You may need to evaluate the loads on those channels to make sure your not overloading them.Chuck Link to comment Share on other sites More sharing options...
Harbs Posted December 8, 2008 Author Share Posted December 8, 2008 Thanks for the reply back.I am using LED's and each channel had only (2) strings of 50 count on them.I would not think this is an overload issue,Would they still be working at higher intensity if the triacs are bad?Harbs Link to comment Share on other sites More sharing options...
cmoore60 Posted December 8, 2008 Share Posted December 8, 2008 I will say that I had a bad triac on one of my kits when I first assembled and tested. I was using only 1 string of 100 ct minis to test.Just contact support@lightorama.com or call LightORama they should be able to fix you up one way or another.Chuck Link to comment Share on other sites More sharing options...
Harbs Posted December 8, 2008 Author Share Posted December 8, 2008 Thanks for your reply.I have emailed Support. I am sure they will have a fix.Harbs Link to comment Share on other sites More sharing options...
Recommended Posts