Steven Posted November 25 Posted November 25 I want to set my legacy CCR to unit ID 0C (DMX address 177), but the hardware utility reports that it was not successful setting it. I successfully set it to 03, 0A, 0B, but attempting 0C and 0D failed. (I didn't try anything else.) This was immediately after upgrading the firmware to the latest 1.19.
TheDucks Posted November 25 Posted November 25 14 hours ago, Steven said: I want to set my legacy CCR to unit ID 0C (DMX address 177), but the hardware utility reports that it was not successful setting it. I successfully set it to 03, 0A, 0B, but attempting 0C and 0D failed. (I didn't try anything else.) This was immediately after upgrading the firmware to the latest 1.19. Betcha even 04 fails also. The 3rd bit is used for 0C, 0D (and 0E,0F) . Does the unit have switches?
Steven Posted November 25 Author Posted November 25 I'll try other addresses with the 3rd bit. The unit is a legacy CR150D that doesn't have address switches.
Steven Posted November 26 Author Posted November 26 Update: It all works now. Only needed a power cycle.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now