Jump to content
Light-O-Rama Forums

Recommended Posts

Posted

I have (2) Pixcon16s, several pixies, one cmb24d and 3 ac controllers in my show. All running from 4 port director.

Both my Pixcon16s have issues not turning on some of the channels. 

I cycled ac power and had them all work one time. But now, after several attempts cannot get all channels operating.

They are the same channels, occurs on both Pixcon16s and ALL other controllers work everytime.

I have the director set to run show on powerup.

The channels on the pixcon16s that do not work are not related to the side of the board, so do not believe its a power supply issue. As I have the first five ports and last 2 ports working correctly.

Do I need to power up the Pixcon16s first then power up the director?

Unsure what to do next. 

Like I stated before both Pixcon16s DID run correctly one time.

Posted

I do not own a director so no advice from me on that. I do own two Pixcon16's. My first quick thought is to look in the "Advanced" command area to see if you have the universes and channels set correctly. Also make sure you have the latest firmware for them.

Posted

Channels all set correctly. Both Pixcon16s did run correctly once on initial plug in.

 

Posted

Should I add terminator jumper on Pixcon16 board?

 

Posted
21 minutes ago, Vince4xmas said:

Should I add terminator jumper on Pixcon16 board?

 

Is it the LAST on the LOR network? If yes, then also YES. Terminate.

Posted

They are BOTH the last on the LOR network. I will terminate both via jumpers on Pixcon16 board.

Thanks Ducks!

 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...