Ed.Faranda Posted November 28, 2008 Share Posted November 28, 2008 I just built the CTB16 board and am having a strange problem. When Channel 1 comes on, so goes 16. When 5 comes on, so does 13. Etc. Seems that the bank is duplicating on the other side.Any ideas? Link to comment Share on other sites More sharing options...
Ed.Faranda Posted November 28, 2008 Author Share Posted November 28, 2008 I've already tried reloading the firmware, with no luck. Link to comment Share on other sites More sharing options...
Ed.Faranda Posted November 29, 2008 Author Share Posted November 29, 2008 Figured it out... Found a short between pins 15 and 16 on U2. Once I removed the solder bridge, it worked perfectly.Root Cause: Don't trust an Engineer with a soldering iron,,, :shock: Link to comment Share on other sites More sharing options...
JeffF Posted November 30, 2008 Share Posted November 30, 2008 Ed.Faranda wrote: Root Cause: Don't trust an Engineer with a soldering iron,,, :shock:Well that's a given isn't it? (Just kidding, except, where I work that is gospel!) -Jeff Link to comment Share on other sites More sharing options...
Ed.Faranda Posted December 1, 2008 Author Share Posted December 1, 2008 Jeffrey wrote: Well that's a given isn't it? (Just kidding, except, where I work that is gospel!) -JeffI have built 8 controllers, I guess 1 soldering bride out of 8 controllers isn't bad. Just a little frustrating when it is 10pm in the evening and your trying to figure out what happened and why your controller is wigging out.(Wigging out is an Engineering term) Link to comment Share on other sites More sharing options...
Recommended Posts