Jump to content
Light-O-Rama Forums

Unable to connect to Hardware Utility


Jon Goering

Recommended Posts

I built a CTB-16 channel deluxe board the other night. Initially the LED didn't work. I checked voltages and all is there. Running a jumper for the LED from both ground pins enabled the LED to light. I ended up finding the problem, the U2 socket was installed correctly, but I put the IC in backwards. Once I changed that, the LED started blinking. But it will not respond to the Hardware Utility. I have an 8 channel (built by LOR) that works with the utility, so I know the utility works and the CAT 5 cable is fine. I used both CAT5 connectors and neither respond. So, I'm wondering did I fry the U2 chip by having it in backwards. What other points can i check for voltages besides whats in the Troublshooting Guide.

Thanks for any help

Jon

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...