Comm Listener Problems on Aux Networks

[dl20415]

During shows, the comm listener keeps closing and opening my Aux ports. This causes the show editor to jump to the next sequence. Im using Aux A through H. I reinstalled all the ports, didn't help.It gives the trouble code Error Sending Packets:5. Can anyone help me?

[dibblejr]

Why did you skip the Regular network?

JR

[TheDucks]

I suspect there is a controller on AuxA that is spewing (garbage data), when it should be listening.

💡 Binary Isolation technique:

Break the network about mid point.

Did the trouble go away?  Y: problem is in the detached group  (reconnect, then) Split that in half . Repeat

N: split the near group. repeat

[dl20415]

I did that and i suspect it might be one of the 2 usb hubs i use. they are both new, but i think one may have a defect.

[dl20415]

i have all my reg controllers, 18 total, on separate comm port plugged directly into computer. no problems. All pixels on Aux networks. The only difference from years past is i replaced the 2 hubs.