Lights

[battchief06]

Ok I have my sequences set up. I went to play them to test it and only 1 rgb bulb lights up, 1/4 of the roof that are traditional lights hooked together. I am at a loss. I can’t figure it out. Can anyone help me troubleshoot this? Thanks

[TheDucks]

15 minutes ago, battchief06 said:

Ok I have my sequences set up. I went to play them to test it and only 1 rgb bulb lights up, 1/4 of the roof that are traditional lights hooked together. I am at a loss. I can’t figure it out. Can anyone help me troubleshoot this? Thanks

Which controller are you using with your RGB lights?

[k6ccc]

And what are you controlling the traditional lights with?  All on one network or more than one?

 

[Orville]

4 hours ago, battchief06 said:

Ok I have my sequences set up. I went to play them to test it and only 1 rgb bulb lights up, 1/4 of the roof that are traditional lights hooked together. I am at a loss. I can’t figure it out. Can anyone help me troubleshoot this? Thanks

The way I read this, and I hope I'm incorrect, but the way it sounds is like you have RGB strands connected to regular AC standard lights or AC L.E.D.' strands.  If so, you're lucky to even have 1 RGB bulb light up.  Because doing this is a sure-fire way to destroy an RGB strand real fast, the magic smoke will come out of something if RGB Lights are trying to be used attached to standard AC strands or an LOR CTB16PC AC Controller.  You need an RGB DC Controller for RGB strands, such as a Pixie controller.

 

Like others have asked: What controllers are you using to control the RGB lights?  And which controller are you using to control your standard AC lights?   As well as are you using more than a single network as Jim asked?  And are you using a computer or Director to run your show?  Also, have you tested this all in the HU?  Did it work, or were there issues as well?

Knowing all this, then someone would be able to give you the correct advice on how to correct your problem.

Edited November 13, 2021 by Orville