Jump to content
Light-O-Rama Forums

Question on Pixel Tree Up and Over Prop with 100 pixel strings


machtoo

Recommended Posts

I am adding a 16x100 tree with Pixie16 for next season.  After looking at the length of the possible 3-4 inch spacing, I chose the 16x100 up and over prop.  I have assumed that by choosing this prop, the software takes care of flipping the image on the "back side" (50 pixels front and 50 pixels on the back of the 360 degree tree),  It does display properly in the preview...the image or effect appears to wrap properly around the tree.  Is this a correct assumption? If this isn't correct it means another Pixie 16 for the back side.  Thanks

Link to comment
Share on other sites

In Preview Design, click on the gear icon at the end of the toolbar, then select Pixel Labels > Pixel Numbers. This will allow you to see where each pixel is physically located. You will need to zoom in to read the labels. See the "Pixel labels" topic on this page:

http://www1.lightorama.com/help/design_tab.htm

Matt

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...