Verifer Does not do anything when I click on it.

[magic]

No screen panel nothing S5 V5.5.16  I launch it from the control panel

[Don]

What is it that you are trying to Verify?

[magic]

The shows entire or a sequence.  It helps with troubleshooting., Like when I add a new prop. 

[dibblejr]

8 hours ago, magic said:

The shows entire or a sequence.  It helps with troubleshooting., Like when I add a new prop. 

Are you using the selection box to point to the show or sequence?

I do this every day while adding a sequence to an existing show. It may not move for a minute or two but then it goes right through. Depending on the sequence it could take longer.

JR

[Orville]

Does it not open at all? 

Or are you seeing a screen that asks you to verify a single show, multiple shows or verify a single sequence at all?

If it's not opening at all, you may need to re-install the software suite again, or it could be a Windows firewall or an Anti-Virus issue that is blocking the program from running {but you should have received a pop up warning from Windows if this were the case}.    I had to make exceptions in my Windows Firewall almost every time I upgraded my LOR software to the next version.   And had to also do it in the Anti-Virus software as well, as some will block it under false positives.

 

[magic]

Thank you for your response. I did reinstall the software and restarted the computer and it works on that one.  Now checking my main computer as it had the same problem.  It showed up when I upgraded to the new version.