Roger Leon Forbes Posted November 25, 2020 Share Posted November 25, 2020 Can anyone tell me how to get sub sequence to run in S5, it loads but will not turn on. Sequence runs great alone. I have emailed LOR but have not gotten an answer on how to make it work. Or will I have to run old program in S4 and forget my S5 work this year. Link to comment Share on other sites More sharing options...
Don Posted November 25, 2020 Share Posted November 25, 2020 I haven't played with sub sequences in S5. However, I wonder if there is a channel overlap going on. If you programmed the sub sequence with the same preview as the regular sequences, then you would have two sets of instructions going to the same controller/channel. Link to comment Share on other sites More sharing options...
Kcan Posted November 25, 2020 Share Posted November 25, 2020 I will check this out. Thank you! Link to comment Share on other sites More sharing options...
Don Posted November 25, 2020 Share Posted November 25, 2020 4 minutes ago, Kcan said: I will check this out. Thank you! I don't think that's your issue, fyi. Link to comment Share on other sites More sharing options...
Recommended Posts