JimCanfield Posted October 27, 2008 Share Posted October 27, 2008 I am now sequencing some voiceovers and as I sequence I play the song with both controllers hooked up with lights attached. When I play this sequence only a few channels turn on. When I go to play other sequences that I have already completed they all play fine. I just tried to make a new animated sequence and only a few channels will light. Could it be because I am using the editor to play the songs? I thought I was told that I could play the lights as I sequence? Link to comment Share on other sites More sharing options...
Ponddude Posted October 27, 2008 Share Posted October 27, 2008 Make sure that you have "Control Lights" checked under the play menu.Also make sure you are on the right network.Are you importing your channel configuration from your other sequences? Link to comment Share on other sites More sharing options...
JimCanfield Posted October 27, 2008 Author Share Posted October 27, 2008 Doesn't it figure, you spend a lot of time trying to figure out a problem, then once you break down and ask you find the answer! My problem was that I had all 32 channels on unit 1 instead on unit 1 and 2. Oh well, at least it works now! Link to comment Share on other sites More sharing options...
Recommended Posts