mrforemark Posted December 15, 2019 Share Posted December 15, 2019 One of my 4 channel controllers isn't behaving correctly. When I turn all the channels on in hardware utility mode only 2 of the 4 channels come on but they go out in a couple seconds. When I plug it in directly with cat 5 cable they all work ok. HELP!!! Link to comment Share on other sites More sharing options...
jfuller8400 Posted December 15, 2019 Share Posted December 15, 2019 I would start by doing a factor reset on the controller. You might also change the frequency that the ELL's are using in case you're getting interference from another source. Link to comment Share on other sites More sharing options...
Recommended Posts