Jump to content

Recommended Posts

This evening I hooked up my USB485-ISO to my indoor ELL and was able to find my 18 controllers. I than went with the USB485-ISO and set unit IDs on 4 other controllers 2 of which run off of ELLs in my neighbors yard. When I returned from setting those Unit IDs I connected my USB485-ISO to my indoor ELL and searched for controllers in the HU and every time it found between 1 and 0. I tried with multiple CAT5 cables and USB cables from PC to USB485-ISO. One thing I noticed is when the PC was connected to the USB485-ISO than to the indoor ELL the TX light was blinking soft. For some reason I thought the RX light should have been the one blinking. I also had the green USB Power and green ISO power LEDs were on. When I looked into the indoor ELL I found LED 1 was blinking normally (about 1 per second) and LED 2 was blinking about dimly about 3 per second. When I hit a refresh in the HU the indoor ELL LED 1 stays the same, LED 2 shimmers like it is trying to stay on but does not. Is this normal? I just ordered another USB485-ISO as I am not sure but I think that might be the issue. I also uninstalled the USB485 driver than reinstalled the software with no difference. I also did a complete LOR install on another computer with the same results. Any other troubleshooting ideas please let me know.

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...